behars Loading... Please wait...

Strong-Bond 104 Electronic Industries Epoxy Adhesive, Special Formulation, 2 Part, Thixotropic

$5.99
Shipping:
Calculated at checkout
Quantity:

Product Description

RIGID EPOXY STAKING COMPOUND RT CURE


PRODUCT DESCRIPTION:

Strong-Bond 104 Electronic Industries Epoxy Adhesive, Special Formulation, 2 Part, Thixotropic is a thixotropic epoxy system recommended for critical electronics, aerospace and industrial bonding, laminating and reinforcing applications requiring an adhesive with high-fill, non-sag characteristics.

Strong-Bond 104 Electronic Industries Epoxy Adhesive, Special Formulation, 2 Part, Thixotropic solvent-free adhesive is easily mixed and used for staking components to printed circuit boards for enhanced mechanical rigidity, and for bonding, laminating and repair applications involving metals, glass, ceramics, wood and many plastics.

Strong-Bond 104 Electronic Industries Epoxy Adhesive, Special Formulation, 2 Part, Thixotropic hardens to a tough, enamel-like coating offering good chemical resistance as well as superior physical and mechanical properties.

Strong-Bond 104 Electronic Industries Epoxy Adhesive, Special Formulation, 2 Part, Thixotropic provides good electrical insulation and resistance to weather, galvanic action, petroleum products and lubricants, alcohol, salts, mild acids and alkalis, and other organic and inorganic compounds.

GENERAL PROPERTIES

Appearance Milky translucent
Cure Type Room temperature or Heat cure
Benefits Great for Aerospace applications
Great for reinforcing applications
Bonds to many substrates
Mix Ratio by weight 100:22 / Resin:Hardener
Substrates metals, glass, ceramics, wood and many plastics
Operating Temperature -60 to 125 C
Typical Application(s) PCB components, aerospace, anything where superior properties are required

UNCURED PROPERTIES:

Solids Content 100%
Specific Gravity, mixed 1.19 g/cc
Pot Life 30 minutes

CURE SCHEDULE:

4 hours @ 65C
24 hours @ 25C

MISC PROPERTIES:

Hardness, Shore D 88
Dielectric Constant 4.6 @ Frequency 1000 Hz
Dielectric Strength 16.1 kV/mm
Volume of resistivity 6.00e+13 ohm-cm
1.00e+10 ohm-cm @ Temperature 100 C

GENERAL INFORMATION:

For safe handling information on this product, consult the Material Safety Data Sheet, (MSDS).

HOW TO USE:

1) Carefully clean and dry all surfaces to be bonded.

2) Apply Strong-Bond 104 Electronic Industries Epoxy Adhesive, Special Formulation, 2 Part, Thixotropic mixed adhesive to the prepared surfaces, and gently press these surfaces together. Contact pressure is adequate for strong, reliable bonds; however, maintain contact until adhesive is completely cured.

3) Some separation of components is common during shipping and storage. For this reason, it is recommended that the contents of the shipping container be thoroughly mixed prior to use.

4) Some ingredients in this formulation provided may crystallize when subjected to low temperature storage.

5) A gentle warming cycle of 52C for 30 minutes prior to mixing components may be necessary. Crystallized epoxy components do not react as well as liquid components and should be re-dissolved prior to use for best results.

AVAILABILITY:

This epoxy can be supplied in various different packages.

Product Reviews

Write Review

This product hasn't received any reviews yet. Be the first to review this product!

TDS | SDS

Back to Top