Clear-Bond 10 Transparent, Epoxy Adhesive, Rigid, Clear, Low Viscosity, Room Temperature Cure is a rigid, optically clear adhesive with a very low viscosity.
Clear-Bond 10 Transparent, Epoxy Adhesive, Rigid, Clear, Low Viscosity, Room Temperature Cure is room temperature system an excellent choice for thin bond-line assembly and repair applications of prisms, lenses and other optic components. And its high strength makes this epoxy ideal for structural applications.
Clear-Bond 10 Transparent, Epoxy Adhesive, Rigid, Clear, Low Viscosity, Room Temperature Cure exhibits excellent wetting and wicking capabilities which allows it to adhere strongly to glass, ceramics, metals and most rigid plastics.
|Appearance ||Transparent, clear |
|Cure Type ||Room temperature or Heat cure |
|Benefits ||High strength |
Perfect insulative properties
Good resistance to salt solutions, mild acids and Alkalis and many other chemicals
|Mix Ratio by weight ||100:11 / Resin:Hardener |
|Operating Temperature ||-60 to 130 C |
|Typical Applications ||Exhibits excellent wetting and wicking capabilities which allows it to adhere strongly to glass, ceramics, metals and most rigid plastics. |
|Volume Resistivity ||6.00e+13 ohm-cm |
|Viscosity @ 25 C ||310 |
|Thixotropic Index ||1.0 |
|Specific Gravity, mixed ||1.16 |
|Reactive solids contents, % ||100 |
|Pot Life ||30 minutes |
|5 minutes ||@ 100C |
|2 minutes ||@ 120C |
|1 minute ||@ 150C |
|Glass transition temperature (Tg), C ||90 |
|Hardness, Shore D ||83 |
|Refractive Index ||1.54 |
|Lap shear strength, psi ||2150 (alum to alum, 24 hrs @ 25C) |
2600 (alum to alum, 1 hr @ 65C)
3000( alum to alum, 4 hrs @ 65C)
|Dielectric Constant ||4.3 @ Frequency 1000 Hz |
|Dielectric Strength ||16.1 kV/mm 410 kV/in |
For safe handling information on this product, consult the Material Safety Data Sheet, (MSDS).
HOW TO USE:
1) Carefully clean and dry all surfaces to be bonded.
2) Apply Clear-Bond 10 Transparent, Epoxy Adhesive, Rigid, Clear, Low Viscosity, Room Temperature Cure completely mixed adhesive to the prepared surfaces, and gently press these surfaces together. Contact pressure is adequate for strong, reliable bonds; however, maintain contact until adhesive is completely cured.
3) Some separation of components is common during shipping and storage. For this reason, it is recommended that the contents of the shipping container be thoroughly mixed prior to use.
4) Some ingredients in this formulation provided may crystallize when subjected to low temperature storage. A gentle warming cycle of 52C for 30 minutes prior to mixing components may be necessary. Crystallized epoxy components do not react as well as liquid components and should be re-dissolved prior to use for best results.
This epoxy can be supplied in various different packages.