How do I use this pouch?

Silver-Easy-Mix 07 Silver Conductive Epoxy Easy 1 to 1 Mix Ratio Adhesive System

$39.99

Shipping:

Calculated at checkout

* Size:

10gm syringes
50gm kit(s)
100gm kit(s)
250gm kit(s)
500gm kit(s)
10ml Easy Dispensing System *New*
50ml Dual Cartridge
Dispensing Gun
Mixing Tip

Quantity:

TDS
Product Review
Find Similar Products by Category

Product Description

PURE SILVER FILLED ELECTRICALLY CONDUCTIVE EPOXY, ONE TO ONE MIX RATIO

PRODUCT DESCRIPTION:

Silver-Easy-Mix 07 Silver Conductive Epoxy Easy 1 to 1 Mix Ratio Adhesive System is an epoxy adhesive and coating formulation based on pure silver. This versatile silver formulation offers the maximum continuity of conductivity with an electrical resistivity value of less than 1x10-4 ohmcm.

Silver-Easy-Mix 07 Silver Conductive Epoxy Easy 1 to 1 Mix Ratio Adhesive System is also characterized by a wide operating temperature range from 50 to +170C.

Silver-Easy-Mix 07 Silver Conductive Epoxy Easy 1 to 1 Mix Ratio Adhesive System is recommended for electronic bonding and sealing applications that require both fine electrical and mechanical properties.

PRODUCT PROPERTIES:

Appearance	Silver
Cure Type	Heat cure or Room temperature
Benefits	High strength Perfect bond Cold solder for heat-sensitive components
Mix Ratio by weight	100:100 / Resin:Hardener
Glass Transition Temp, Tg	50 C
Minimum Bond Line Thickness	1mm
Substrates	Excellent choice aluminum, copper, magnesium, steel, bronze, nickel, kovar, ceramic, glass, phenolic and G-10 epoxy glass boards.
Typical Applications	Electrical, conductive, rmi/efi shielding, circuitry, printed circuit board and electronics repair

UNCURED PROPERTIES:

Viscosity @ 25 C cps	Paste
Specific Gravity, mixed	2.79
Reactive solids contents, %	100
Pot Life	1 Hour
Shelf Life	6 Months

CURE SCHEDULE:

15 minutes	@ 100C
45 minutes	@ 50C
24 hours	Room temperature

CURED PROPERTIES:

Hardness, Shore D	85
Shrinkage linear in/in	0.0003
Lap shear strength, psi	9400
Volume Resistivity ohm. cm	< 0.0001
Thermal Expansion Coefficient, (cm / cm / C 10-5)	1.5
Thermal Conductivity, btu / hr / ft2 / F / in	100
Tensile Strength, psi	9,500
Compressive Strength, psi	14,000
Heat Distortion, C	170
Operating Temperature C	-50 to +170

GENERAL INFORMATION:

For safe handling information on this product, consult the Material Safety Data Sheet, (MSDS).

HOW TO USE:

1) Carefully clean and dry all surfaces to be bonded.

2) Apply Silver-Easy-Mix 07 Silver Conductive Epoxy Easy 1 to 1 Mix Ratio Adhesive System completely mixed adhesive to the prepared surfaces, and gently press these surfaces together. Contact pressure is adequate for strong, reliable bonds; however, maintain contact until adhesive is completely cured.

3) Some separation of components is common during shipping and storage. For this reason, it is recommended that the contents of the shipping container be thoroughly mixed prior to use.

4) Some ingredients in this formulation provided may crystallize when subjected to low temperature storage. A gentle warming cycle of 52C for 30 minutes prior to mixing components may be necessary. Crystallized epoxy components do not react as well as liquid components and should be re-dissolved prior to use for best results.

AVAILABILITY:

This epoxy can be supplied in various different packages.